Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Lid Tamper Fault
18-10-2012, 06:24 AM,
#1
Lid Tamper Fault
Hi, I have a Cooper Menvier Scantronic 9651 alarm panel with a 9330 keypad that is showing a Lid Tamper fault, I have a user manual but not the engineer/service manual. We have just had some building work completed and the code appeared after they had moved one of the PIR's. I have read through the forum and tried to enter my code twice, also tried 0123, but to no avail. Any more help would be very much appreciated, as I would like to get the smoke detectors working as a matter of some urgency.
Reply
18-10-2012, 12:42 PM,
#2
RE: Lid Tamper Fault
Hi,

At the rear of the keypad is a microswitch which presses against the wall, sort of. Ensure that it is doing so and also ensure that the keypad lid is replaced correctly. I shall activate your account and send some manuals since you have had builders in, and that usually means a bit more trouble than we first thought.

Take care.
Reply
18-10-2012, 12:51 PM,
#3
RE: Lid Tamper Fault
Hi,

your account is activated, which means that you can send and receive private messages and e.mails. This is important for yourself since engineer codes are not allowed on open forum. At first glance, I would suggest that the builders have done something to your detector, check that the lid is on correctly.

Check your e.mails. Manual sent as attachment.

Engels
Reply
18-10-2012, 05:49 PM,
#4
RE: Lid Tamper Fault
Has the lid of the main control panel been opened at all?
Proforce Fire and Security
Intruder Alarms, Fire Alarms, CCTV, Access Control
07534 402330 http://www.proforcefireandsecurity.co.uk
Reply
21-10-2012, 02:06 PM,
#5
RE: Lid Tamper Fault
[quote='firesi83' pid='20286' dateline='1350578944']
Has the lid of the main control panel been opened at all?
[/quote]

Yes I'm afraid I took it off in the vain hope there was any extra information on the inside of the panel.

diyer
Reply
21-10-2012, 02:43 PM,
#6
RE: Lid Tamper Fault
Hi,

Check your e.mails... manuals sent as attachments.

Engels.
Reply
21-10-2012, 07:04 PM,
#7
RE: Lid Tamper Fault
Thankyou very much for your assistance, all seems to be working now.

Best Regards diyer
Reply


Please note that new posts in this forum must be approved by a moderator before becoming visible.
[-]
Quick Reply
Message
Type your reply to this message here.

Image Verification
Please enter the text contained within the image into the text box below it. This process is used to prevent automated spam bots.
Image Verification
(case insensitive)

Possibly Related Threads...
Thread Author Replies Views Last Post
  Fault on scantronic 9651 lid tamper active with orang steady light Mrudd 0 210 21-01-2013, 08:54 PM
Last Post: Mrudd
  Tamper feed engels7570 9 913 15-10-2012, 09:37 PM
Last Post: engels7570
  Disable tamper. engels7570 10 739 14-10-2012, 04:47 PM
Last Post: engels7570

Forum Jump:


Users browsing this thread: 1 Guest(s)